Wall Connector for Insulated Wall — W11010W10

You look at the wall of your house and think — how do I attach a beam here, without crushing the insulation?

This connector is the answer. Engineered specifically for walls with 10 cm insulation, it reaches through to the hard surface behind — giving your beam a rock-solid foundation, without compromising your thermal envelope.

What You Get:

• A solid, load-bearing base for a 10×10 cm KVH timber beam directly on the hard wall surface — no insulation compression
• Only two narrow strips of insulation need to be cut (20×5×10 cm each) — exactly where the bracket flanges pass through
• Secured with chemical anchors through 4 wide holes into the hard surface
• Gaps sealed with low-expansion foam through the central hole — no thermal bridge
• Slide in the beam and lock it — done

Technical Specs:

• Material: 4 mm steel with reinforced welded plates
• Finish: matte black powder coat with fine texture
• 6 holes: 4 wide for chemical anchors + 1 central for foam injection
• Compatible with 10×10 cm KVH timber beams
• Designed for walls with 10 cm insulation

Built to last. An investment in peace of mind — once installed, never revisited.